Stepper Motor Drive Indexer - 9.8Arms/13.8A
peak 115 VAC) |
Independent controllers can be found in all areas of industrial
machine control. This has not been true for most stepper motion
applications.
Separate indexer controls are commonly associated with stepper
motor drives and stepper motors as the principle components
in any stepper motion system...until now.
Besides trademark AMCI reliability, the SD17098I was engineered
to power AMCI's complete line of high torque stepper motors,
ranging in size from NEMA 23 to NEMA 42. If your application
calls for an efficient stepper motor drive indexer,
look no further.
Programming and motion commands are issued through the self-contained
network connection. Available network connectivity includes
ControlNet, DeviceNet, EtherNet/IP, or ProfiBus.
Stepper Motor Drive
Indexer - 9.8Arms/13.8A peak 115 VAC) |
Network Connectivity:
- SD17098IC (ControlNet)
- SD17098ID (DeviceNet)
- SD17098IE (Ethernet IP)
- SD17098IP (Profibus) |
ELECTRICAL SPECIFICATIONS:
|
|
Stepper Motor Drive
Indexer - 9.8Arms/13.8A peak 115 VAC) |
Amplifier type:
Bipolar with two MOSFET H-bridges; average
current control, 20 kHz PWM |
Number of phases:
(2) two |
Input power:
95-132 Vac, 50/60 Hz, 10 Amps max |
Encoder input:
5 Vdc differential |
Note:
AMCI stepper motors are designed for 170 Vdc operation.
Other manufacturer's motors may not be compatible with
the SD17098i 170V bus. Contact motor manufacturer for
compatibility. |
OPERATIONAL SPECIFICATIONS: |
|
Stepper Motor Drive
Indexer - 9.8Arms/13.8A peak 115 VAC) |
Current rating:
9.8 Arms (average current) / 13.8A peak (peak
current)
NOTE: There
are 2 ways to express the magnitude of current in microstepping
stepper motor drivers, RMS and Peak.
1 amp RMS = 1.414 amp Peak.
AMCI's SD17098i stepper motor drive indexer is rated
for 9.8 amp RMS or 13.8 amp
Peak.
|
Maximum velocity:
motor/lead dependent |
Output current:
1.0A through 9.8A in 0.1A increments, programmable from
the network |
Maximum operating temperature:
50° C ambient temperature |
Idle current:
40% to 100% after 3 seconds without a step |
Motor connections:
Eight lead series or parallel, six lead series or center
tapped, or four lead motors |
Breakout box wiring:
A 25 pin breakout box and an interface cable
is included with each SD17098I.
|
Stepper Motor Drive
Indexer - 9.8Arms/13.8A peak 115 VAC) |
Hardware protection:
Interlock connection to prevent damage if motor
connector is removed with power applied. Short circuit
protection - phase to phase and phase to ground. Overtemperature
circuitry. |
Stepper Motor Drive
Indexer - 9.8Arms/13.8A peak 115 VAC) |
Underwriters Laboratories Inc.
Listed:
UL508C
|
Stepper Motor Drive Indexer - 9.8Arms/13.8A
peak 115 VAC) |
AMCI makes buying Stepper Drives easy...our sales office
will help you:
Contact AMCI Sales today:
telephone: 860-585-1254
email: sales@amci.com |
24-75
VDC input: 
